Hobart 3613 & 3713 Bedienungsanleitung

NSTRUCTIONSIMODEL 3613 & 3713 SLICERSMODELS 3613 Manual Slicer ML-136143 3713 Automatic Slicer ML-136144701 S. RIDGE AVENUETROY, OHIO 45374-000

– 10 –Using the Knife Removal Tool Accessory Unplug the machine power cord andturn the index knob fully clockwise to close thegauge plate before clean

– 11 –To Reinstall the Knife . . .• Orient the RIDGE on the KNIFE HUB so it points to the PIN onthe RING GUARD at the 1 o'clock position (Fig. 24

– 12 –FORM 35218 (Oct. 2007)MAINTENANCE Unplug the machine power cord and turn the index knob fully clockwise toclose the gauge plate before doing any

– 2 –© HOBART CORPORATION 2007TABLE OF CONTENTSGENERAL . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3Acces

– 3 –Installation, Operation, and Care ofMODEL 3613 & 3713 SLICERSSAVE THESE INSTRUCTIONSGENERALThe model 3613 and 3713 slicers are equipped with

– 4 –PRODUCT TRAYThe PRODUCT TRAY (Fig. 1) must be installed on the slicer.To install the PRODUCT TRAY on the slicer,lower the bottom of the SUPPORT A

– 5 –SHARPENER ROD & PIN SHARPENERMOUNTSLOTFig. 4ELECTRICAL This machine is provided with a three-prong grounding plug. The outlet to whichthis pl

– 6 –Fig. 9Fig. 8Fig. 7PARK PIN IN MEAT GRIP SLOTPRODUCT TRAYMEAT GRIPSLIDE RODMEAT GRIP ARMTOP KNIFE COVERLATCH KNOB PRODUCT TRAYMEAT GRIP I

– 7 –SLICING — MODEL 3713• Close the GAUGE PLATE by turning the INDEX KNOB fully clockwise (Fig. 7).• Pull the PRODUCT TRAY (Fig. 7) all the way towar

– 8 –CLEANINGThis machine must be thoroughly cleaned and sanitized at least as often as required by local regulationor after being idle for an extende

– 9 –Clean completely around the RING GUARD by working amoistened, folded paper towel between the RING GUARD and theKNIFE (Fig. 15).Wash, rinse and sa